Starting Up The Scanner System - Kodak PROFESSIONAL HR 500 Plus User Manual

Connecting and Operating the Scanner

Starting Up the Scanner System

NOTE: If the scanner's power has been on and the scanner has been calibrated,
IMPORTANT: Before operating the scanner in a production environment for the
Placing the Empty Film Holder in the Film Holder
Guide
The empty film holder must be in place in the film holder guide when you power up
the scanner.
edge of handle facing back
of scanner
1. With the edge of the top handle facing the back of the scanner, center the film
2. Lower the film holder and let it gently fall into place in the scanner.
3. With your finger, apply pressure to the handle to make sure the film holder is
2-6
continue with Operating the Scanner beginning on page 2-8.
first time, validate that the scanner is working properly. See
Chapter 3, Validating the Scanner.
Film Holder for
HR 500 Plus Film Scanner
70MM-CAL
holder between the two rails of the film holder guide.
fully seated.
Get other manuals https://www.bkmanuals.com
Film Holder for
HR Universal Film Scanner
4 x 5
70MM-CAL film holder
film holder guide
P192_0020GC
May 2002