Table of Contents
Advertisement
Appendix C: Scanner Specifications
AC Power Requirements
AC Frequency
AC Phase
Operating Environment
Dimensions and Weight
Operating and Service
Clearances
Scanner Location
Power Consumption
and Thermal Load
AC Voltage and Current
Draw
May 2002
Site Specifications
1,750 watts peak
50 or 60 Hz
Single
Room temperature:
65 to 80° F (18 to 27° C)
Relative humidity:
20 to 70%
Ambient light:
less than 1000 lux; no exposure to direct lighting
Altitude:
7000 feet (2134 m) maximum
Scanner Specifications
Height:
15 in. (38,1 cm)
Width:
24 in. (61 cm)
Depth:
30 in. (76,2 cm)
Weight:
120 lbs (54,5 kg)
Footprint: 5 square feet
Rear:
1.5 feet (45,7 cm) for operation,
3 feet (91,4 cm) for service
Sides:
2 feet (60 cm) for operation and service
Front:
4 feet (122,9 cm) for operation and service
The scanner location relative to the host workstation is limited by the SCSI
interface cable length; if you are using a cable stocked by Kodak, this
distance is 2 meters or less. Longer cables are not supported for use with
the scanner. The scanner must be the only SCSI device attached to the
host computer.
The scanner should be located on a table that:
•
is stable
•
can support approximately 120 lbs (54,5 kg)
•
is at least 30 in. (76,2 cm) long x 30 in. (76,2 cm) wide
Power Consumption: 425 watts maximum; 400 watts typical
Thermal Load:
1325 BTU operating; 1230 BTU standby
100 V AC/50 Hz
4.2 amps operating;
100 V AC/60 Hz
4.1 amps operating;
120 V AC/50 Hz
3.5 amps operating;
200 V AC/60 Hz
2.0 amps operating;
200 V AC/50 Hz
2.0 amps operating;
230 V AC/60 Hz
1.8 amps operating;
250 V AC/50 Hz
1.75 amps operating; 1.65 amps standby
Get other manuals https://www.bkmanuals.com
3.9 amps standby
3.85 amps standby
3.2 amps standby
1.9 amps standby
1.85 amps standby
1.7 amps standby
C-1
Advertisement
Table of Contents
