Connect The Grounding Cable; Step 4: Connect Power To The Acx5048 Router; Connect Ac Power To An Ac-Powered Acx5048 Router - Juniper ACX5048 Quick Start Manual

Connect the Grounding Cable

Step 4: Connect Power to the ACX5048 Router

Connect AC Power to an AC-Powered ACX5048 Router

Copyright © 2015, Juniper Networks, Inc.
To connect earth ground to an ACX5048 router:
Secure the provided protective earthing terminal bracket through the ACX5048 router's
1.
mounting bracket to the chassis with the nut provided. The posts on the protective
earthing terminal bracket must point to the left. See
Figure 5: Connecting a Grounding Cable to a 1 U ACX5048 Router
Connect one end of the grounding cable to a proper earth ground, such as the rack in
2.
which the router is mounted.
Place the grounding lug attached to the grounding cable over the protective earthing
3.
terminal on the protective earthing terminal bracket.
Secure the grounding lug to the protective earthing terminal with two nuts.
4.
Dress the grounding cable and ensure that it does not touch or block access to other
5.
router components and that it does not drape where people could trip over it.
Depending on your configuration, your router uses either AC or DC power supplies. Perform
the appropriate procedures for each power supply in your router.
The power supply in an ACX5048 router is a hot-removable and hot-insertable
field-replaceable unit (FRU). You can remove and replace it without powering off the
router or disrupting router functions.
WARNING: You must ground the router before connecting the power cables.
Connect AC Power to an AC-Powered ACX5048 Router on page 7
Connect DC Power to a DC-Powered ACX5048 Router on page 8
The ACX5048 router is supplied with two factory-installed power supplies.
Connect the Grounding Cable
Figure 5 on page 7.
7