Table of Contents
Advertisement
6. Remove the eight (M2.5x5) screws that secure the display assembly to the computer.
7. Slightly lift the bottom assembly and slide it to the left and away from the display assembly. Remove the display assembly
from the computer.
NOTE:
The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is
removed from the bottom chassis. If any components in the display assembly are malfunctioning and need to be
replaced, replace the entire display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION:
The information in this installation section is intended for authorized service technicians only.
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
65
Advertisement
Table of Contents
