Solid-State Drive; Removing The M.2 2230 Solid-State Drive - Dell NOT22422 Owner's Manual

Steps
1. Connect the battery FPC cable to the connector on the system board.
2. Tighten the two captive screws to secure the battery connector bracket in place.
3. Align and place the base cover on the palm-rest assembly, and snap the base cover into place.
4. Replace the eight (M2x3) T5 Torx screws to secure the base cover to the computer.
Next steps
1. Install the SD card.
2. Follow the procedure in

Solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the SD card.
3. Remove the base cover.
About this task
CAUTION: The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
NOTE: The following procedure is applicable for models shipped with an M.2 2230 solid-state drive in the SSD1 and/or
SSD2 slot.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
45