Table of Contents
Advertisement
Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. For systems shipped with an integrated GPU card, tighten the three captive screws in ascending order (1>2>3) to secure
the heat sink to the system board.
3. For systems shipped with a discrete GPU card, tighten the seven captive screws in ascending order (1>2>3>4>5>6>7) to
secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
heatsink
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
62
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
for systems shipped with vapor chamber VC heatsink.
computer.
computer.
Before working inside your
Advertisement
Table of Contents
