Table of Contents
Advertisement
NOTE:
Tuck the display FPC into the gap between the system board
and the palm-rest before connecting the display FPC to the system board.
5. Replace the two (M1.4x4) T5 Torx screws to secure the display FPC cable in place.
6. Flip close the display FPC cover.
7. Replace the two (M1.4x4) T5 Torx screws to secure the display FPC cover in place.
Next steps
1. Install the
heatsink
for systems shipped with vapor chamber VC heatsink.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
SD-card reader daughterboard
Removing the SD-card reader daughterboard
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the battery.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
NOTE:
The following procedure is applicable for computers shipped without a USH module only.
The following images indicate the location of the SD-card reader daughterboard and provide a visual representation of the
removal procedure.
68
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Before working inside your
Advertisement
Table of Contents
