Table of Contents
Advertisement
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
M.2 solid-state
5. Remove the
VPU
card, for systems shipped with a VPU card.
6. Remove the Battery.
7. Remove the
left
fan.
8. Remove the
right
fan.
9. Remove the heatsink.
10. Remove the
system
board.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
NOTE:
The following procedure is applicable for systems shipped with a USH and SD card reader daughterboard FPC only.
The following images indicate the location of the USH and SD card reader daughterboard FPC and provide a visual
representation of the removal procedure.
Steps
1. Remove the two (M1.4X1.2) screws that secure the USH and SD card reader daughterboard FPC in place.
2. Disconnect and remove the USH and SD card reader daughterboard FFC cable from the connector on the system board.
drive, for systems shipped with a solid-state drive.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
107
Advertisement
Table of Contents
