3. Tighten the six captive screws on the base cover.
4. Replace the two screws (M2.5x5) that secure the base cover to the palm-rest assembly.
Next steps
1. Follow the procedure in
M.2 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE: This procedure applies only to computers shipped with a M.2 2230 solid-state drive installed.
NOTE: Depending on the configuration ordered your computer may have up to two M.2 cards installed. Supported card
configurations per M.2 card slot:
•
M.2 2230 solid-state drive + 2230 mounting bracket
•
M.2 2280 solid-state drive
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal
procedure.
14
After working inside your
Before working inside your
computer.
computer.