Panasonic DVD-CV50 Operating Instructions Manual page 38

You can enjoy the 5.1 -channel surround sound found on DVD recorded with Oolby Digital or DTS Digital Surround by connecting an amplifier with
a built-in decoder or a separate decoder-amplifier combination.
,w.,
Beck of the unit
Note when connecting the optical digital audio cable
Dust o ion teig ,coiInthe
plug with the
• Remove the dust protection cop from the op_col digital audio
output terminal and connect the cable firmly so that the
configurations of both the cable and the terminal match.
eKeep the dust protection cap and reattach when not using the
terminal.
I
OPTICAL COAXIAL I
Optical digital audio cable
eDo not bend the optical digital audio cable when connecting it.
Coaxial audio cable
Amplifier with a built-in decoder
eRead the instructions for the amplifier and speakers for connection
details.
Speakers
(You con connect from 3 to 5 speakers including the front two.)
eFront speakers (L/R)
eCenter speaker
eSurround speakers (L!R)
eSubwoofer
When you have finished connection
Make changes to "7 Digital Audio Output" to suit your decoder (=, page 40).
er
PCM Down Conversion
Dolby Digital
DTS Digital Surround
Dolby Digital decoder
DTS DigitalSurround
decoder
Yes • Yes •
Bitstream PCM
Off Sitstream
Dolby Digital/
DTS Digital Surround
decoder
Yes •
Bitstream
Bitstream
,_If this is set to "No", no audio will be output when DVDs recorded in 96 kHz linear PCM are played. (Audio will be output as it is if the DVD does not
have copyright pmtactien recorded on it.)
eThese changes to digital audio output must be made, otherwise bitatream signals the decoder cannot handle will be output. If these
signals are output, "noise" will be output which can cause harm to your ears and speakers.
eln "8 Speaker Setting", select "2 2-channel" (-_ page 42).
The sound for speakers ether than the front left and dght speakers will not be heard if you de not select "2 2-channel".
You cannot use DTS Digital Surround decoders not suited to DVD.
RQT5455