Information On The Device; Declaration Of Conformity; Included In The Scope Of Supply - Dimplex DEE 1521 Assembly And Operating Instructions Manual

English
ATTENTION!
Before installing the device, ensure that the
power supply is disconnected and the water
supply is shut off.
Establish the water connection before connecting

the electricity.
According to standard EN 60335-2-35, instanta-

neous water heaters used for shower applications
must be limited to a maximum of 55 °C (see
chapter 4.9.2.).
The specific electrical resistance of the water

must not be less than 1300 Ohm/cm. Ask the
local water utility company about the electrical re-
sistance of the water.
The device is suitable for the water supply of sev-

eral points of use, including bathtubs.
On the rear of the device, create only those open-

ings that are necessary for installation. If you are
re-installing the device, any openings that are not
used must be sealed water tight.
Live parts must not be accessible after mounting.

1.1.4 Cleaning, maintenance
Do not use any abrasives or solvents or alcohol-

based products for cleaning.
Do not use steam cleaners.

Maintenance may only be performed by licenced

professionals.
Prior to any maintenance work, disconnect the

device from the power.
If limescale forms, clean or replace the spray reg-

ulator or shower heads.
EN-4
1.1.5 Children and impaired persons
This device may be used by children aged 3 years and
above as well as persons with reduced physical, sen-
sory or mental capabilities or lack of experience and
knowledge provided that they have been given super-
vision or instruction concerning use of the device in
a safe way and understand the risks involved.
Children must no play with the device.
Cleaning and maintenance must not be performed by
unsupervised children.
2

Information on the device

2.1

Declaration of conformity

This product complies with European and national re-
quirements in terms of design and operating behaviour.
ity is available on the internet at: www.dimplex.de.
2.2

Included in the scope of supply

Isolating valve

Connecting nipple ½" (2x)

Screws (4x)

Dowels (4x)

Flat gaskets (4x)

Flow limiter disc

Jumpers (2x)

Fastening material

Documents for the device

6721873500 (2023/07)
DEE 1521, DEE 2127
The CE marking declares the conformity of
the product with all applicable EU legisla-
tion providing for the affixing of this mark-
ing.
The full text of the declaration of conform-
www.dimplex.de