Table of Contents
Advertisement
English
NOTE
The opening of the cable entry must tightly enclose
the power supply line so that no water can enter. If
necessary, seal the cable entry.
Adjust the cable entry to the diameter of the power
supply line.
Feed the power supply line through the cable entry,
making sure that it is well sealed.
Correct cable entry (top section of the graphic)
NOTE
The power supply cable must be inserted at least 40
mm into the device, unless you have chosen the lower
connection point for short cables.
EN-12
Unevenness between the device and the wall in the
range of 2-8 mm can be compensated by adjusting
the upper mounting device.
If necessary, use the lower spacers (1) to align the rear
of the device parallel to the wall.
6721873500 (2023/07)
DEE 1521, DEE 2127
www.dimplex.de
Advertisement
Table of Contents
