DEE 1521, DEE 2127
Snap the sealing diaphragm back onto the rear wall.
Connect the supply line to the connection terminals
of the device.
NOTE
Position the power supply line so that the cover of the
device can be fastened without obstruction.
5.2
Installing the device covers
Before attaching the cover, connect the control cable
of the control panel to the printed circuit board.
NOTE
If the control panel is not connected, the device is set
to a temperature of 42 °C.
www.dimplex.de
Affix the cover of the device (A, B, C).
Tighten the fastening screw of the cover (D).
Attach the front panel (E)
6721873500 (2023/07)
English
B
A
C
D
E
EN-19