English
Procedure for the connection at the bottom for short
cables
Loosen the snap-in connection by pushing it with
a screwdriver.
Remove the sealing membrane of the device.
EN-18
Pull on the end of the cable entry to unfold the cable
guard.
Cut the end of the cable entry according to the diam-
eter of the power supply cable so that it seals tight.
Guide the power supply line through the cable entry
so that at least 10 mm of the sheathing of the power
supply line is covered.
Dimension for sheathing of the power supply line
A
≥ 10 mm
6721873500 (2023/07)
DEE 1521, DEE 2127
www.dimplex.de