Table of Contents
Advertisement
English
Engage the hydraulic block in the lateral holders (D).
D
E
Attach flat gaskets (E) to the water connections and
tighten water connections.
Check that the system is sealed tight.
4.8
Purging the device
Open the water inlet.
Open the hot water valve (1) for one minute to purge
the device.
EN-14
D
E
6721873500 (2023/07)
4.9
Specifying the operating parameters
The following parameters can be pre-set:
maximum electrical power
maximum hot water temperature
Priority switching in connection with other con-
sumers (e.g. electric heating, stove).
Several parameters can be defined.
ATTENTION!
This must only be performed by licensed
professionals. Disconnect the device from
the power supply prior to performing any
work.
Set the parameters with the included link cables.
Retain removed link cables.
DEE 1521, DEE 2127
www.dimplex.de
Advertisement
Table of Contents
