Lubrication; Greasing The Bearings - Toro TimeCutter MyRIDE Owner's Manual

Lubrication

Greasing the Bearings

1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine and wait for all moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag.
Note:
fittings.
4. Connect a grease gun to each fitting.
5. Pump grease into the fittings until grease
begins to ooze out of the bearings.
6. Wipe up any excess grease.
Maintenance: Lubrication
Scrape any paint off the front of the
position.
ARK
G451140
Page 5–5 3466-517 A