Raising The Machine - Toro TimeCutter MyRIDE Owner's Manual

Moving a Non-Functioning Machine (continued)
5. Disengage the parking brake by moving both motion-control levers down to the center,
unlocked position.
Note:
6. Move the machine as required.
Always push the machine by hand. Do not tow the machine, because towing may
damage it.
7. Move the motion-control levers outward to the P
8. Move both bypass levers rearward and over through the slotted hole to lock them in
place

Raising the Machine

Use jackstands to support the machine when you raise it.
Supporting the machine on the lower muffler shield may damage the shield and
cause the machine to fall, injuring you or bystanders.
Do not use the lower muffler shield to lift or support the machine.
3466-517A
Do not start the machine.
.
IMPORTANT
position.
ARK
WARNING
G451399
Page 5–4 Maintenance: Pre-Maintenance Procedures