Raising the Front of the
Machine
If the front of the machine needs to be raised, use the very
front edge as shown in
Figure
Important: To prevent damage to the steering
mechanism, use the very front edge of the machine for
a jacking point.
Figure 35
35.
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the lubrication
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Ensure that the parking brake is engaged, shut off the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Clean the grease fittings
a rag.
Note: Make sure to scrape any paint off the front of
the fitting(s).
g028320
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting
Figure
37).
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
31
points.
(Figure 36
and
Figure 36
Figure 37
3. Grease every 25 operating
hours
4. Engine
(Figure 36
Figure
37) with
g027752
decal106-8717
and