Table of Contents
Advertisement
Signal Stalker II Object (STLK)
A Signal Stalker Object (STLK) stores the parameters
necessary for the radio to rapidly sweep a range
y to
of frequencies for strong signals from nearby
transmitters. A STLK object can be used for
standalone operation—the radio just sweeps and
stops when activity is detected, or for stalking that
you
is performed while the radio is scanning. During
lic
scanning, the radio will check for activity on all the
/
enabled Scannable Objects: TGRP objects, CONV
objects, LMIT objects and STLK objects.
arch
Essential Parameters
By default, a newly created STLK object is
ready to go without any changes. In its default
configuration, the STLK object will sweep through
ual
all of the important land mobile radio bands
and look for strong signal activity from nearby
s to
transmitters. You may wish to include or exclude
some bands in your sweeps in order to check other
VC
frequency ranges or to limit the amount of time
the scanner spends sweeping frequency ranges
where local transmitter activity is less likely. See
"Appendix B: Detailed Menu Reference: STLK Menu" on
page 122 for detailed menu information.
To create a new STLK object:
1. Press PGM to place your scanner into
2. Press
3. Press
4. Scroll down to
Refer to "Dedicated Signal Stalker II" on page 64 or
"Appendix A: Search Bands" on page 100 for sub-
band frequency information.
Program Mode.
softkey, then press
NEW
view the available Search types.
softkey.
STLK
to change between
Safety.
Object Searches
SRCH
and press u if you want
Type:
All Bands
59
softkey to
and
Public
Advertisement
Table of Contents
