Descaling - DeLonghi ECAM13.12 Series Instructions For Use Manual

4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig.30);
Important!
DO NOT USE WASHING UP LIQUID TO CLEAN THE INFUSER AS
IT MAY DAMAGE IT.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
6. Clean coffee residues from the support where the infuser
rests;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support, then push the PUSH symbol fully in until it
clicks into place;
Please note :
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers (fig. 31).
8. Once inserted, make sure the two coloured buttons have
snapped out (fig. 32).
9. Close the infuser door;
10. Put the water tank back.

14. DESCALING

Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• It is important to use De'Longhi descaler only. Using un-
suitable descaler and/or performing descaling incorrectly
•
Descale the appliance when the
control panel (B) flashes.
1. Turn the appliance on and wait until it is ready for use;
2. Empty the drip tray (A17) and grounds container (A13) and
3. Empty the water tank (A9) completely and remove the
4. Pour the descaler (C3) into the tank up to level A (corre-
31
32
5. Place a container with a minimum capacity of 1.8 litres
13
may result in faults not covered by the manufacturer's
guarantee.
Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler De'Longhi descaler
Container Recommended capacity: 2 l
Time ~45min
put both back in the machine;
water softener filter (C4), if present;
sponding to a 100 ml pack) marked on the inner surface of
the tank (fig. 33), then add a litre of water up to level B (fig.
34) and put the water tank back in the appliance;
B
A
A
33
35
under the cappuccino maker (A18) and coffee spouts (A12)
(fig. 35);
button (B3) on the
B
A
B
34
5 sec
36