DeLonghi ECAM26.455 Instructions For Use Manual
Bean to cup espresso and cappuccino machine
Hide thumbs
Also See for ECAM26.455:
- Instructions for use manual (24 pages) ,
- Getting started (16 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for DeLonghi ECAM26.455
Summary of Contents for DeLonghi ECAM26.455
- Page 1 5713216211/ 05.11...
- Page 2 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for use ECAM26.455...
- Page 6 CLEAN...
-
Page 7: Table Of Contents
MAKING DRINKS WITH MILK........13 CONTENTS Filling and attaching the milk container ......... 13 INTRODUCTION ............7 Adjusting the amount of froth ..........13 Symbols used in these instructions ........... 7 Making drinks with milk automatically ........14 Letters in brackets ..............7 Cleaning the milk frother with the CLEAN button .... -
Page 8: Introduction
INTRODUCTION Thank you for choosing the ECAM 26.455 automatic coffee and enabling the appliance to be unplugged when necessary. cappuccino maker. We hope you enjoy using your new appliance. Never pull the power cable as you could damage it. Take a few minutes to read these instructions. This will avoid all risks and damage to the machine. -
Page 9: Description
B11. HOT MILK button: to deliver a cup of milk (When in the Please note: settings menu, press to scroll forwards) Keep these instructions B12: button: to deliver steam If the appliance is passed to other persons, they must also be B13. -
Page 10: Using The Appliance For The First Time
Connecting the appliance If your model is not provided with a filter, you can request one from De’Longhi Customer Experience. Important! Check that the mains power supply voltage corresponds to TURNING THE APPLIANCE ON the value indicated on the rating plate on the bottom of the appliance. -
Page 11: Menu Settings
Auto-start MENU SETTINGS You can set the auto-start time in order to have the appliance When you access the programming menu by pressing the MENU/ESC ready at a certain time (for example in the morning) so you can button, the following menu items are available: make coffee immediately. -
Page 12: Cup Warmer
“Enable?” if the function has been disabled);o To disable or re-enable the beep, proceed as follows: 4. Press the button to disable (or enable) energy 1. Press the MENU/ESC button to enter the menu; saving mode; 2. Press the HOT MILK or LATTE button (fig. 8) until “Beep” 5. -
Page 13: Making Coffee
coffee is too thin and not creamy enough or that delivery is too MAKING COFFEE slow (a drop at a time), this can be corrected by adjusting the Selecting the coffee taste grinding adjustment dial (fig. 12). The appliance is set by default to make coffee with a standard Please note! taste. -
Page 14: Making Coffee Using Pre-Ground Coffee
coffee buttons ( MAKING DRINKS WITH MILK Please note! in the cup, just press (within 3 seconds) one of the coffee buttons ( always clean the milk container lid and hot water nozzle Once the coffee has been made, the appliance is ready to use as described in the section “Cleaning the milk container”... -
Page 15: Making Drinks With Milk Automatically
Making drinks with milk automatically Programming the quantity of coffee and milk in the The CAPPUCCINO, LATTE, FLAT WHITE and HOT MILK buttons cup for the CAPPUCCINO, LATTE, FLAT WHITE and HOT on the control panel enable these drinks to be prepared MILK buttons. -
Page 16: Delivering Steam
To modify these quantities, proceed as follows: sponge and warm water. 1. Position a container under the spout. 6. Reinsert the nozzle and replace the cappuccino maker on 2. Press the button again until “Hot water Program the nozzle, turning it and pushing it upwards until it is quantity”... -
Page 17: Cleaning The Inside Of The Coffee Maker
To remove the drip tray: 4. Press the two red release buttons inwards and at the same 1. Remove the drip tray and the grounds container (fig. 26); time pull the infuser outwards (fig. 31). 2. Empty the drip tray and grounds container and wash 5. -
Page 18: Cleaning The Hot Water/Steam Nozzle
2. Remove the milk spout and DESCALE intake tube. Descale the machine when the message “DESCALE” flashes on 3. Turn the froth adjustment the display. dial to the “INSERT” position Important! (see figure) and pull it off upwards. eyes. 4. Wash all the components It is vital to respect the manufacturer’s safety warnings thoroughly with hot water given on the descaler pack and the warnings relating to... -
Page 19: Setting The Water Hardness
Remove the water tank, empty, rinse under running 6. Press the MENU/ESC button to exit the menu. water, fill with clean water and replace. The machine is now reprogrammed with the new water “Rinsing... Confirm?” is displayed. hardness setting 8. Empty the container used to collect the descaler solution WATER FILTER and replace it empty under the hot water spout. -
Page 20: Replacing The Filter
10. The message “Enable?” is displayed. 3. Press the MILK or CAPPUCCINO button (fig. 8) until 11. Press the button to confirm the selection. “Hot “Install filter Enabled” is displayed; water Confirm?” is displayed. 4. Press the button 12. Position a container with a minimum capacity of 100 ml 5. -
Page 21: Displayed Messages
DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY Fill the tank with water and/or insert it correctly, pushing it FILL TANK as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A22) is full. Empty the grounds container and drip tray, clean and replace (fig. -
Page 22: Troubleshooting
TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact De’Longhi Customer Experience. PROBLEM POSSIBLE CAUSE REMEDY The cups were not preheated. The coffee is not hot minutes to warm up. Warm the cups by rinsing them with hot water (N.B.