Energy Saving; Keypad Access Code; Setting Clock And Schedule - TCS SuperSTAT Series Configuration Manual

Configuration

Energy Saving

STEP 1 Delay on Powerup: In the event of a power interruption,
entering a value (in seconds) that will delay the powerup of the
SuperSTAT.
STEP 2 Smart Recovery: Select whether to use Smart Recovery
Mode.
NOTE: Smart Recovery is not available when DI3 (see
Inputs: STEP 4" on page
time clock.

Keypad Access Code

STEP 1 Programming Access: Select whether an access code is
required to access Programming Setup.
NOTE: Use a dip switch to lock out access completely (see
""Programming Keypad Access" on page
STEP 2 Clock and Schedule Access: Select whether an access code
is required to access the Clock and Schedule menus.
NOTE: Use dip switch settings to lock out access completely
(see ""Programming Keypad Access" on page
STEP 3 Access Code: This screen will appear if you configured
an access code requirement for either the Programming
Setup or Clock and Scheduling Setup om the previous two
steps. Select an access code value (0 – 255) to access the
Programming Mode and/or the Clock and Schedule Mode.
The default value is 248.

Setting Clock and Schedule

NOTE: Access to the Clock and Schedule Mode can be completely disabled via dip switch settings (see
Keypad Access" on page
page 10).
The main screen displays when not in Programming Setup Mode or
CLOCK SETUP Mode. The SuperSTAT will revert to this screen if no
entries are made after 10 minutes.
From the main screen, press the CLOCK SETUP button on the keypad to
configure the settings.
If the SuperSTAT has been configured to require an access code to
enter Programming Mode, this screen will appear
Code" on page 10). If you enter the wrong code, the screen will revert
to the main screen.
10
9) is configured for an external
4).
4, or access can be restricted by requiring an access code
(see "Keypad Access
2800 Laura Lane • Middleton, WI 53562
DELAY ON POWERUP
ENABLE SMART
"Digital
RECOVERY?
REQUIRE CODE FOR
PROGRAMMING?
REQUIRE CODE FOR
CLOCK/SCHED?
4).
ENTER ACCESS
CODE
TUE
9:00 AM
ENTER ACCESS
CODE
| 800.288.9383 | www.tcsbasys.com
010 SECONDS
"Programming
(see "Keypad Access Code" on
07-04-23
NO
YES
YES
248
72F
000