Economizer - TCS SuperSTAT Series Configuration Manual

Configuration
STEP 7 Cool Stage 1 Offset: Enter an offset value for cool stage 1.
(Heat stage 1 is normally 0° offset).
STEP 8 Cool Stage 1 Differential: Enter a differential value for cool
stage 1.
STEP 9 Cool Stage 2 Offset: Enter an offset value for cool stage 2.
NOTE: This screen appears only if cool stage 2 is enabled
(Step 2).
STEP 10 Cool Stage 2 Differential: Enter a differential value for cool
stage 2.
NOTE: This screen appears only if cool stage 2 is enabled
(Step 2).
STEP 11 Control Mode: For configuring staged outputs, select whether
to control by temperature only (P) or include a time factor
(P+I).
STEP 12 Outdoor Air Sensor Function: Select whether you are using
an outdoor air sensor for control. If monitoring only, select
NO.
NOTE: Refer to
switch settings, which must also be set.
STEP 13 Cooling Lockout: Select an outdoor air cooling lockout
temperature.
NOTE: This screen appears only if the outdoor air sensing
function is enabled (Step 12).
STEP 14 Heating Lockout: Select an outdoor air heating lockout
temperature.
NOTE: This screen appears only if the outdoor air sensing
function is enabled (Step 12).

Economizer

STEP 1 Discharge Air Sensor Function: Select whether you are using a
discharge air sensor for control. If monitoring only, select NO.
NOTE: Steps 2 – 8 will only appear if you are using a discharge
air sensor. Refer to
switch settings, which must also be set.
STEP 2 Outdoor Air Economizer: Select the outdoor air setpoint.
8
SuperSTAT 1041 Installation Manual
SuperSTAT 1041 Installation Manual
2800 Laura Lane • Middleton, WI 53562
COOL STAGE 1
OFFSET:
COOL STAGE 1
DIFF:
COOL STAGE 2
OFFSET:
COOL STAGE 2
DIFF:
SET CONTROL
MODE
ENABLE OUTDOOR
AIR FUNCT.?
for dip
COOLING LOCKOUT
TEMP
HEATING LOCKOUT
TEMP
ENABLE DISCHARGE
FUNCT.?
for dip
OUTDOOR AIR ECON
SETPOINT:
| 800.288.9383 | www.tcsbasys.com
00F
01F
00F
01F
P
YES
065F
070F
YES
068F