Juniper ACX7348 Hardware Manual page 130

2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to an ESD point on the chassis. An ESD point is located on the front of the ACX7348
router (see Figure 74 on page 121
3. Label the cables connected to each port on the FPC so that you can reconnect the cables to the
correct ports.
4. Take the FPC offline by using the
status information by using the
5. To unlatch the ejector handles, grasp both the ejector handles using your hands by placing your
thumb on top of the ejector handle and your index finger below the ejector handle. Pull down the
ejector handles simultaneously and slide the FPC out of the slot (see
Figure 75: Removing an ACX7348 FPC
6. Place the FPC on the antistatic mat. Be careful not to bump or handle the FPC by the connectors. If
you do not have an antistatic mat, have another person help you slide the antistatic bag over the FPC
before placing it on a stable surface.
CAUTION: Do not stack hardware components on top of one another after you
remove them. Place each component on an antistatic mat resting on a stable, flat
surface.
).
request-chassis-fpc slot
show chassis fpc command.
slot-number offline
command. Verify the
Figure 75 on page
122
122).