Juniper ACX7348 Hardware Manual page 104

10. (Optional) Give the router a name. If the name includes spaces, enclose the name in quotation
marks (" ").
[edit]
root@re0# set system host-name
11. Configure the default gateway.
[edit]
root@re0# set routing-options static route 0.0.0.0/0 next-hop destination-ip
12. Configure the IP address and prefix length for the management port on the router. On the
ACX7348, the management port (MGMT) is the RJ-45 port on the Routing Engine.
[edit]
root@re0# set interfaces re0:mgmt-0 unit 0 family inet address
13. (Optional) Configure specific static routes to remote prefixes if you do not want the remote prefixes
to use the default route.
[edit]
root@re0# set routing-options static route address/prefix-length next-hop
14. Enable Telnet service, if required.
[edit]
root@re0# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to the ACX7348 using root credentials.
Root login is allowed only for SSH access.
15. Enable SSH service.
[edit]
root@re0# set system services ssh
host-name
address/prefix-length
destination-ip
96