Philips 107T60 Service Manual page 96

96
107T6 CRT
Go to cover page
Uninstall
should you need to remove the LightFrame software, please follow
these steps.
1) First, click on the start menu.
2) Next, highlight Settings.
3) Then, click on Control Panel.
4) Now, click on Add/Remove Programs
5) Finally, select LightFrame from the list and then click on the
Add/Remove button.
Operating LightFrame
after installation, LightFrame starts up automatically whenever the
computer is started. At system start up, LightFrame checks the selected
resolution of the monitor and if the monitor is LightFrame capable.
Icon and Colors
An icon of a monitor represents LightFrame on your desktop. This icon
appears as a shortcut on the Windows desktop. LightFrame has three (3)
modes of operation: Active, Inactive, and Suspended. The same icon
Active =The LightFrame taskbar as below.
Inactive = The taskbar as below.
Suspended = The taskbar as below.
Notes:
An active window must be 100% visible, i.e. It must be on top of all other
windows or areas. If any part of another window or area overlaps a
highlighted window, LightFrame automatically suspends operation. Once
that window or area is removed and the original highlighted window is on
top again, LightFrame automatically re-engages and the icon regains its
bright green center.
An active window must also be 100% on the monitors viewing area. If
part of a highlighted window moves off the monitors viewing area,
LightFrame automatically goes into the Suspended mode. If part of a
window is off the viewing area, you will not be able to use LightFrame
on that window.
Only one window or area at a time can be highlighted.
How To Activate LightFrame
1) Click on the LightFrame icon
be changed to Fig. B.
2) Guide the mouse to the window you want displayed. As you move the
mouse, the cursor changes to a small arrow with a light bulb.
LightFrame for Windows (Continued)
Fig. A in the system tray. The icon will
Fig. A
Fig. B
3a) Click on the window you want to have highlighted. The brightness
and sharpness are automatically adjusted.
3b) If you want to highlight only an area of a window, click on the left
mouse button and drag the cursor over the area to be highlighted
while holding the mouse button. A rectangle forms around the area.
When the area is encompassed by the rectangle, release the mouse
button and the area becomes highlighted.
How to Deactive LightFrame
To deactive, click on the LightFrame icon in the system Tray of the
Taskbar, Click icon as Fig. 1 and Taskbar will be changed to
Fig. 2 and LightFrame is deactivated.
Fig. 1
Note
If a highlighted window is closed before LightFrame is deactivated,
LightFrame is automatically deactivated.
Fig. 2