Philips 107T60 Service Manual page 71

GENERAL PRODUCT SPECIFICATION
4.5 Picture tilt
With respect to Fig. 3, Tilt to be measured on extremes of center line from bezel.
|A- B|: £ 2 mm
4.6 Geometrical distortions (For preset modes only)
It is acceptable that pincushion, trapezoid, rhomboid,
rotation and various waves distortions must remain within
the limits of tolerance as in Fig. 4,
where A = B = 2.0 mm.
C = D = 2.0 mm.
The waviness of any vertical or horizontal shall be less than 1.0 mm over a 50 mm distance.
4.7 Image non-linearity (For preset modes only)
Apply cross-hatch pattern with
12 equal blocks along horizontal axis,
9 equal blocks along vertical axis. (see Fig. 1)
Overall : £ 10 %
Adjacen: £ 6 %
H. non-linearity =
(Xmax + Xmin)/2
Ymax. - Ymin
V. non-linearity =
(Ymax + Ymin)/2
4.8 Mis-convergence
The maximum convergence error to be measured on a white spot or white display line to
represents the maximum distance between the energy centers of any two primary colors
(See Fig. 6). For 31.5kHz modes B Zone : 0.4mm.
CONVERGENCE SPEC.
Zones
Zone C
Zone A
Zone B
17" V32 GS4 107T6-71K CMTR
TYPE
BRAND : PHILIPS
2004-04-19
Wayne Lin
Xmax. - Xmin
x 100%
x 100%
0.25 mm CRT
0.15 mm
0.25 mm
0.35 mm
:107T60/00
2004-04-16
8639 000 15483
16
31
107T6 CRT
71
Go to cover page