Philips 107T60 Service Manual page 72

72
107T6 CRT
Go to cover page
4.9 Focus check ( 68.7 KHZ / 85 HZ )
Adjust brightness control to center(50%) and contrast control to get 25 FL at full white pattern, then
generate
display area. (See Fig. 8)
4.10 Luminance uniformity
condition : With full white pattern, set contrast control at maximum(100%)
4.11 White color adjustment
Based on the 1931 CIE chromatic diagram (x,y) coordinates
of white display on screen center should be:
For 9300 ° K
For 6500 ° K
For sRGB
Check conditions : Set brightness control at center(50%) and contrast at maximum(100%).
For sRGB mode sRGB contrast is at Factory value.
4.12 Color tracking on full white pattern
Adjust for the luminance output from 3 to 30 FL by pressing the contrast control key
(brightness control at 50%).
The color co-ordinates should not deviate more than the following tolerance when
compare to display center:
X= X (center) ± 0.015
Y= Y (center) ± 0.015
4.13 Purity
Test patterns : Full white / Red / Green / Blue.
Conditions
After warming-up time of 30 min., no color stains may occur in the above four patterns.
4.14 Moire
Condition: Display a full white pattern. At any preset mode ,
The clouding effect must not rise to disturbing levels in anywhere of the screen with
luminance setting from 15 to 30 FL.
2004-04-16
Wayne Lin
GENERAL PRODUCT SPECIFICATION
me characters to cover the entire picture. The characters should be clearly identified in all
and brightness control at center(50%).
Brightness of the center of the display is 30 FL+/-5.
The Max. deviation over the screen should not exceed 25%
X = 0.283 ± 0.015
Y = 0.297 ± 0.015
X = 0.313 ± 0.015
Y = 0.329 ± 0.015
X = 0.313 ± 0.015
Y = 0.329 ± 0.015
: As stated in item 4.0, the purity must be checked under specific
destinations of earth magnetic environments and the monitor
must be well degaussed.
the display size must be set as Fig.1.
17" V32 GS4 107T6-71K CMTR
TYPE :107T60/00
BRAND : PHILIPS
2004-04-16
8639 000 15483
31
17