Ddc Instructions - Philips 107T60 Service Manual

28 107T6 CRT
Go to cover page
2. Access Factory Mode
1). Turn off monitor.
2). [Push "
" & "
] + [Press power " " button untill comes out "Windows screen"]
=> then release all button, then press
with
Characters V32 107T6 V0.24 20040303 (below OSD menu) come on
the Screen of the monitor (see Fig. 23).
MODEL SELECT MODEL SELECT
Factory
V32 107T6 V0.24 20040303 V32 107T6 V0.24 20040303
Mode-------------
Indicator
3. Click (Write EDID) icon from the tool bar to write DDC data.
Bring up " ready" a progressing bar on the left, then bring up the
Window as shown in Fig.24, click the " enter" button to finish Writing
ENTER
4. Confirm Serial Number in User Mode
1) Press the button to turn off the monitor. Press the
again to turn on the monitor.
2) Press the button to bring up the OSD main menu.
3) Press the button to select Extra Controls, press the
confirm your selection.
4) Confirm the Serial Number ''TY 000812'' is updated as shown in
Fig. 25.
DDC Instructions (Continued)
" buttons at the same time and hold it
, wait until the OSD menu
Fig. 23
Fig.24
000812
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click
And give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into DDC IC for DDC
Data application.
107T6-DDC
Save
2. Click
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 26.
button
button to
(Save) icon (or click "file"-> "save as") from the tool bar
107T6
107T6-DDC
.
Fig. 26
Fig. 25