Philips 107T60 Service Manual page 69

GENERAL PRODUCT SPECIFICATION
100mmx100mm block
Brightness at center and contrast at maximum light output is 41+/-6 FL.
sRGB : When sRGB mode is selected, the light output (Full white pattern) shall be 23 +/-
3FL regardless of main contrast and brightness controls. Adjusting contrast or brightness
will auto exit sRGB mode and go to 6500K mode.
3.6.3 Raster light output
Apply 68.7KHz/85Hz mode with no video pattern, set brightness at center(50%) and
control at minimum(0%).
The light output on the screen center should be < 0.2FL.
3.7 Variation of image size ( For preset modes only )
Due to brightness change
Long term (Static) : <1.50mm on left/right side
(See Fig.7) <1.20mm on top/bottom side
Due to aging
(25° C, 300 hrs)
Due to mains voltage
variation ( ± 10% )
3.8 Degaussing
An automatic degaussing circuit is provided which requires no intervention. The degaussing
shall be activated and work effectively at the time of switch-on or switch-on again or pressing the
manual degaussing key after the degaussing circuit has been switched off for longer than 30 minutes
(The PTC should be completely cooled off).
3.9 Phosphor protection
The display device is sufficiently protected against the burning of phosphors in
case of repetitive power cycling or absence of horizontal deflection.
3.10 Low emission requirements (MPRII/TCO 03/TCO99)
------------------------------------------------------------------
Items
Alternating Electric
Field
Magnetic Field
Electrostatic
Potential
17" V32 GS4 107T6-71K CMTR
TYPE
BRAND : PHILIPS
2004-04-19
Wayne Lin
: £ 1.0 %
: £ 1.0 %
: £ 1.0 %
Band I
ELF (rms)
MPRII < 25 V/M MPRII < 2.5 V/M
TCO < 10 V/M
MPRII < 250 nT
TCO< 200 nT
< +/- 500 V
:107T60/00
2004-04-16
Band II
VLF (rms)
TCO < 1.0 V/M
MPRII < 25 nT
TCO < 25 nT
8639 000 15483
31
107T6 CRT
Go to cover page
contrast
14
69