Wirescope Software; Probe Detection; Digital Fault Finding; Software Upgrades - Agilent Technologies WireScope 350 User Manual

Br‡‡vtÃT‡h…‡rq
Xv…rTp‚ƒrÃT‚s‡h…r

WireScope Software

Probe Detection

Digital Fault Finding

Software Upgrades

Standard Warranty

1−20
The WireScope software automatically detects which probes are
connected to the WireScope 350 and DualRemote 350, and configures
the testing program to match those probes. Conflicts between the
installed probes and testing selections generate an error message.
The WireScope's software automatically pinpoints cable fault locations
and causes, speeding problem resolution and increasing operator
productivity.
Software upgrades for the WireScope 350 are available for download
from the Agilent Technologies website,
http://wirescope.comms.agilent.com/
See Upgrading the WireScope Software, on page 2-7, and refer to the
ScopeData Pro User's Guide for instructions for downloading software
to the WireScope 350.
The DualRemote 350 uses the same software as the WireScope 350. The
Remote Calibration procedure detects any mismatch in software
versions. To upgrade the DualRemote 350 after upgrading the WireScope
350, perform a calibration. The WireScope 350 will guide you through the
procedure for downloading software from the WireScope 350 to the
DualRemote 350.
The standard one-year limited warranty against defects in materials and
workmanship is contained in the Read Me First information packet
supplied with your kit. Optional extended warranties for analyzers and
accessories are available, as described in the information packet and on
the Agilent Technologies website, http://wirescope.comms.agilent.com/