Table 31 Paper Sensor Commands - TransAct Ithaca 280 Programmer's Manual

Programming Codes
Function Select Paper Sensor(s) to Output Paper-End Signals
ASCII [ESC] c 3 <n>
Hexadecimal 1BH 63H 33H <n>
Decimal <27> <99> <51> <n>
0  n  255
Range
Description ESC c 3 n selects whether to output paper-end signals or not to a parallel
interface. The default setting is n=15. The paper roll low, paper roll end, and
validation sensors can be selected. When the sensors are selected to output
signals and any sensor detects a paper-end, the paper-end signal is output.
When all sensors are disabled, and a paper out is detected, status is always a
paper present. The paper roll low sensor is enabled when either bit 0 or bit 1 or
both is on. The paper roll end sensor is enabled when either 2 or 3 or both bits is
on. The validation sensor is enabled when either 6 or 7 or both bits are on. This
command is enabled only with a parallel interface and is ignored with a serial
interface.
The paper sensor(s) used to output paper-end signals are selected by using n as
follows:
Bit Off/On
0 Off
On
1 Off
On
2 Off
On
3 Off
On
—
4-5
6 Off
On
7 Off
On

Table 31 Paper Sensor Commands

Note: The electronic journal will not stop the printer. Bits 0,1,2 and 3 all
control the receipt station.
28-04430
Hex Decimal
00 0
01 1
00 0
04 2
00 0
04 4
00 0
08 8
— —
00 0
40 64
00 0
80 128
Rev K
®
iTherm 280 Programmer's Guide
Function
Paper roll low sensor disabled.
Paper roll low sensor enabled.
Paper roll low sensor disabled
Paper roll low sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Paper roll end sensor disabled.
Paper roll end sensor enabled.
Undefined.
Validation sensor disabled.
Validation sensor enabled.
Validation sensor disabled.
Validation sensor enabled.
Page 203