Ethernet 10-Base-T Adapter; 802.11B Wireless Interface - TransAct Ithaca 280 Programmer's Manual

Specifications and Requirements
Pin Signal
1 Vbus (+5 V dc) (Not used in the iTherm
2 Minus data
3 Plus data
4 Ground
Note: The standard USB interface does not have enough power to run the
printer.

Ethernet 10-Base-T adapter

An IP addressable 10-Base-T Ethernet adapter is available for the iTherm
It provides for web page configuration and supports bi-directional RAW and Telnet
interfaces. All protocols are implemented to the extent necessary to support printing
from Windows™ platforms; specific protocols supported include the following:

Line Printer Daemon Protocol (LPR) – RFC1179

Simple Network Management Protocol (SNMP) – RFC1157

Printer MIB – RFC1759

Port 9100 (Raw data)

Service Location Protocol (SLP) – RFC2165

The TFTP Protocol (Revision 2) – RFC1350

Telnet COM Port Control Option – RFC2217

Hypertext Transfer Protocol – HTTP/1.1 – RFC2616
Refer to the 100-05072 Wired Ethernet Programmer's Guide for features and additional
setup information.
Note: The Ethernet adapter supports only the Ithaca Cash Drawer
interface.

802.11b Wireless Interface

An 802.11b wireless interface is available for the iTherm
operation of the printer within a specified distance of a base unit. Contact TransAct
technical support for more information on this interface.
28-04430
iTherm
®
280)
®
280 printer, allowing wireless
Rev K
®
280 Programmer's Guide
®
280 printer.
Page 25