TransAct Ithaca 280 Programmer's Manual page 108

Programming Codes
[ESC] $ Cancel user-defined characters
ASCII [ESC] $
Hexadecimal 1BH 24H
Decimal <27> <36>
IPCL none
Description The [ESC] $ command removes all user-defined characters from the
printer's memory. After the user-defined characters are canceled, the
internal character set is printed.
[ESC] > Enable user-defined characters
ASCII [ESC] > <n>
Hexadecimal 1BH 3EH <n>
Decimal <27> <62> <n>
Range <0>, <1>, 0, or 1
1 Enables the characters
0 Disables the characters
IPCL none
Description The [ESC] > <n> command enables or disables the user-defined
characters. The internal character set is printed.
[ESC] y <11> Enable OCR characters
ASCII [ESC] y <11>
Hexadecimal 1BH 79H 0BH
Decimal <27> <121> <11>
IPCL &%YX011
EPOS [ESC] y <11>
Description The [ESC] y <11> command replaces 30 characters in the currently
selected character set with OCR-MA3 characters. OCR characters are
only available in NLQ mode; NLQ mode is automatically selected when
OCR is enabled.
Note 1: Do not switch out of NLQ mode until after the OCR characters are
disabled. Other fonts do not contain these characters and will not print
correctly.
Note 2: The characters printed by the iTherm
format defined in the ANSI X3.111-1986 Standard. They should be
printed in ten or 12 cpi. By enabling enhanced print, the characters have
improved definition but print at a slower speed.
Page 96
iTherm
®
280 Printer follow the
Rev K
®
280 Programmer's Guide