TransAct Ithaca 280 Programmer's Manual page 278

TM
ITherm Extended Printer Control
Function Print Current Configuration and Totals
ASCII [ESC] y <9> or [ESC] ~ <9>
Hexadecimal 1BH 79H 09H
Decimal <27> <121> <9>
Description This command forces the printer to print the current configuration. To
function correctly it must be issued with the printer in the proper emulation
mode. It is intended to be printed in the default Ithaca
will print in any configuration.
Note: This command must be preceded with an ESC y <8>.
Function Print Current Totals
ASCII [ESC] y <15>
Hexadecimal 1BH 79H 0FH
Decimal <27> <121> <15>
Description This command forces the printer to print the current totals log.
Note: This command must be preceded with an ESC y <8>.
Function Print Current Print Setup Values
ASCII [ESC] y <20> or [ESC] ~ <20>
Hexadecimal 1BH 79H 14H
Decimal <27> <121> <20>
Description This command forces the printer to print the current setup values.
Note: This command must be preceded with an ESC y <8>.
Function: Set Electronic Journal Print Configuration Control
ASCII: [ESC] ~ j <n>
Hex: 1BH 7EH 6AH
Decimal: <27><126><105>
Description: This command reconfigures the electronic journal print mode record
separator and manual printing modes
Where n = 76543210
------X0
------X1
------0X
------1X
Note: Both parameters must be set at the same time by this command.
Note: The record separation configuration may be set in manual
configuration mode. This command will reset the configuration to the
value specified here.
Page 266
Bit values
Manual Electronic Journal Print mode is Enabled
Manual Electronic Journal Print mode is Disabled
A Record separation line is printed that may contain a
record number.
No Record separation line is printed.
Rev K
®
iTherm 280 Programmer's Guide
®
configuration but