Page Mode - TransAct Ithaca 280 Programmer's Manual

Programming Codes
Function Select Paper Type for Command Settings
ASCII [ESC] c 1 <n>
Hexadecimal 1BH 63H 31H <n>
Decimal <27> <99> <49> <n>
n = 1, 1 n 3, 8 n 11
Range
Description ESC c 1 n selects paper type(s) for setting. Paper roll and validation paper are
available. Both bits 0 and 1 indicate paper roll and if either of them is available,
the paper roll is selected as the print sheet. The commands that need to select
paper types for setting are ESC 2, ESC 3, GS L, and GS W. The value of n is
used as follows:
Bit Off/On
0
1
2
3
4–7
Function Select Paper Type for Command Settings
ASCII [ESC] f <t
Hexadecimal 1BH 66H <t
Decimal <27> <116> <t
0 t 15
Range
1
0 t 64
2
Description ESC f t1 t2 sets the time that the printer waits for validation paper to be inserted
1 minutes, and the time from detection of the validation to the start of
to t
1
printing to t
the printer continues waiting for a validation to be inserted. The default validation
waiting time is not set, and the start operation time is set to 10 seconds ( t
=10). This setting alone, however, does not cause the printer to immediately
t
2
start waiting for a validation to be inserted. The setting becomes effective when
validation paper is used. DLE ENQ is used to cancel the validation waiting state.

Page Mode

Function Cancel Print Data in Page Mode
ASCII [CAN]
Hexadecimal 18H
Decimal <24>
Description CAN In page mode, deletes all the print data in the current printable area.
Page 216
Hex Decimal
Off 00
On 01
Off 00
On 02
— —
Off 00
On 08
— —
><t >
1 2
><t >
1 2
><t >
1 2
0.1 seconds. When t1=0, the validation waiting time is not set and
2
Rev K
®
iTherm 280 Programmer's Guide
Function
0 Not Used.
1 Not Used.
0 Paper roll disabled.
2 Paper roll enabled.
—
Undefined.
0 Validation paper disabled.
8 Validation paper enabled.
—
Undefined.
=0,
1