TransAct Ithaca 280 Programmer's Manual page 140

Programming Codes
Function Report on user store
ASCII [ESC] [US] q <0>
Or [ESC] [US] ? <0>
Hexadecimal 1BH 1FH 71H
Decimal <27> <31> <113>
IPCL &%UQ <Name..> <0>
EPOS [GS] 3
Description The [ESC] [US] q <Name..> <0> command prints a status report. The file
name is ignored and may be omitted. The NUL must be present. The
intention of the command is to aid in macro development.
The terminating <0> may be replaced with an & or redefined. See [ESC]
[EM]T<n> or &%UT<n> on page 128.
Note: The report is also printed as part of the configuration report.
Function Redefine User Store Termination Character
ASCII [ESC] [EM] T <n>
Hexadecimal 1BH 19H 54H <n>
Decimal <27> <25> <84> <n>
IPCL &%UT <n>
EPOS None
Description This command allows the terminator used to signal the end of the name
field in User Store commands to be modified. The value of <n> is used
(in addition to the <0>) for the terminator. The value of n may be from 0
to 255.
The default value for the second terminator is &.
redefines the terminator to something other than &, the & will no longer
function.
Example If &%UT% were sent to the printer, the user store command to run macro
"Demo" would be &%URDemo%.
Page 128
iTherm
Print a user store report
Return a formatted user store report
Rev K
®
280 Programmer's Guide
If this command