Setup; Loose Parts; Installing The Grass Deflector - Toro Wheel Horse 78361 Operator's Manual

Setup

Note: Determine the left and right sides of the machine
from the normal operating position.

Loose Parts

Note: Use the chart below to identify parts used for assembly.
DESCRIPTION
Grass deflector
Torsion spring
Washer, 1/2 in.
Cotter pin, 3/4 in.
Plastic washer
Rubber bushing
Jam nut, 3/8 in.
V belt
Idler assembly
Belt cover
Locknut
Operator's Manual
Warning
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
Never put your hands or feet under the mower.
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to Off and rotate the ignition key to Off.
Also remove the key and pull the wire off the
spark plug(s).
QTY.
1
1
1
1

Installing the grass deflector

2
1
1
1
1
Installing the mower
1
1
1 Read before operating
Installing the Grass Deflector
1. Locate items shown in figure 2.
2. Place the straight end of the spring into the small hole
in the discharge chute (Fig. 2).
3. Position spring and discharge chute over post on rear of
deck and secure with a washer (1/2 in.) and a cotter pin
(3/4 in.) (Fig. 2).
4. Slide rubber bushing and plastic washer over stud at
front of mower.
5. Place discharge chute over stud and secure with a
plastic washer and jam nut (3/8 in.) (Fig. 2).
6
USE