Hoover HF7 12 I Instructions For Use Manual page 9

40000369.qxd 18/09/2003
Testing the installation
Refer to the programme guide for details of how to select programmes.
For stopping each programme before its completion, the programme must be
cancelled by holding down the Départ/Pause button for five seconds. The display
will inform you that the programme has been cancelled.
1. Turn on the water supply and check for leaks from the fill hose.
2. Switch on the electricity supply.
3. Select spin programme 15 and then press the Départ button to start the
machine. Allow the programme to continue for one minute and then cancel the
programme (Please see 'Description of controls' section for cancelling the
programme). This will remove any water remaining in the machine from factory
testing.
4. To check for cold water filling to the machine:
Select a rinse programme and press the Départ button to start the machine.
Allow the tumble action to continue until the water has pumped out.
Check that the drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the cycle by turning the control knob to
the Arrêt position.
6. If the machine takes longer than one minute to empty check the drain hoses
for kinks.
Installation testing is now complete.
11:42 Page 9
9