Hoover HF7 12 I Instructions For Use Manual page 16

40000369.qxd 18/09/2003 11:42 Page 16
When you turn the programme selector dial and after the welcome message has
disappeared, you will see a display showing the following details:
Reading from left to right:
1. The programme number
2. The programme name
3. The wash temperature
4. The degree of soiling (how dirty the wash load is)
5. The spin speed
Example:
1 WHITE COTTON
90° HEAVY 1600 RPM
Départ/Pause Button
DEPART
To start a programme press this button once. The Porte Sécurisée light will illuminate. The
machine will now be sensing the wash load and ask you to please wait –
Example
SETTING WASHING
PARAMETERS: PLS WAIT.
The Inter@ct panel will then display the time to complete the programme and then the
wash cycle will commence. Inter@ct calculates the time to the end of the selected
programme based upon a standard 7 Kg load, during the cycle, Inter@ct corrects the time
to that applicable to the size and composition of the load.
Example:
TIME TO END 1H:50M
WASHING 19:30
This display also shows the current phase of the cycle and in the bottom right hand corner,
the current time is displayed.
This display will change throughout the wash programme as the cycle develops.
PAUSE
The programme may be paused at any time during the wash cycle by holding down the
Départ/Pause button for about two seconds and a beep will sound. A message will appear
on the display to inform you that the programme has been paused. To restart the
programme press the Départ/Pause button once again. The display will inform you that the
programme will continue.
Example:
WHITE COTTON
PROGRAMME PAUSED
16