Hoover HF7 12 I Instructions For Use Manual page 7

40000369.qxd 18/09/2003
Note: we recommend you keep the transit bracket and
screws to protect the machine for future transit.
The Manufacturers will not be responsible for any
damage to the machine caused by not following the
instructions relating to releasing the transit protection.
The user is responsible for all installation costs.
Connecting the fill hose
This machine has an inlet hose with a 19mm (3/4") threaded ferrule fitted to the
end to attach between the threaded connector on the appliance and the water
supply.
Only use the new hose supplied to connect the machine and ensure that the
sealing washer is in place inside the hose connector.
Do not re-use old hoses which are attached to existing installations.
Do not over-tighten the connection. Hand tight is sufficient.
Do not trap or kink the hose.
1. Connect the elbow end of the hose to the back
of the machine.
2. Connect the straight end of the hose to the
stop taps.
Acqua-stop (fitted to certain models)
The fill hose supplied with this machine has a
double skin and incorporates a water valve (A). If
the inner hose bursts the valve will automatically
shut off the water supply to prevent flooding. The
indicator turns red (B).
Should this happen, turn off the water supply
immediately and have a new fill hose fitted by
Hoover Service.
11:42 Page 7
7
A
B