Table of Contents
Advertisement
To replace the component, reverse the removal procedure.
Removing and replacing a DIMM
CAUTION: Failure to properly handle DIMMs can damage the DIMM components and the system board connector. For
more information, see the DIMM handling guidelines in the troubleshooting guide for your product on the Hewlett
Packard Enterprise website:
•
HPE ProLiant Gen10 (https://www.hpe.com/info/gen10-troubleshooting)
•
HPE Synergy (https://www.hpe.com/info/synergy-troubleshooting)
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard Enterprise website
(http://www.hpe.com/docs/memory-population-rules).
To identify the DIMMs installed in the server, see DIMM slot locations.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack (Extending the server from the rack).
•
Remove the server from the rack (Removing the server from the rack).
•
4. Remove the access panel (Removing the access panel).
56
Removal and replacement procedures
Advertisement
Table of Contents
