Table of Contents
Advertisement
CAUTION: Be sure to tighten each heatsink nut fully in the order indicated. Otherwise, boot failure or
intermittent shutdowns might occur.
c. Using a T-30 Torx screwdriver, fully tighten each heatsink nuts in the order indicated on the heatsink label (1 -2 -3
-4) until it no longer turns.
21. Install all components removed from the failed system board.
Be sure to install the DIMMs and HPE Persistent Memory modules in the same DIMM slots as the failed system board.
22. Install the access panel.
23. Install the power supplies.
24. Connect the power cord to the power supply.
CAUTION: Connect the power cords using only the following supported configurations. Using an unsupported
power supply or cabling configuration can result in an unexpected loss of system power.
•
Two power supply configuration—For redundancy, connect power supplies 1 and 2 to separate AC power circuits.
Removal and replacement procedures
95
Advertisement
Table of Contents
