Problem Solver; What To Do When A Message Is Displayed - Epson SC-F2200 Series User Manual

SC-F2200 Series User's Guide

Problem Solver

What to Do When a Message Is Displayed

If the printer displays one of the messages shown below, refer to the solution listed and take the necessary steps.
Message
It is time to clean the Sensor
Cover.
The Sensor Cover cannot be
recognized.
It is time to clean the Encoder
Scale.
See your documentation for
details.
Printing has stopped.
Check whether there is an
obstruction inside the printer,
and then press [OK].
Cannot move the movable base.
Check around the movable base,
and then press [OK].
Failed to inspect the condition of
nozzles.
Cannot run "Auto Cleaning".
Select cleaning strength manually
and run Cleaning.
No reprint data found.
A memory device or USB memory
stick is required to reprint.
See your documentation for
details.
Problem Solver
What to do
The surface of the Sensor Cover is dirty. See the following to do cleaning.
"Cleaning the Sensor Cover" on page 80
If you continue to use the printer while the Sensor Cover is dirty, the sensor cannot
correctly detect the position of the platen, so printing may not be done at an
appropriate head height. We recommend cleaning it immediately if this message is
displayed.
The encoder scale is dirty. See the following to do cleaning.
"Cleaning the Encoder Scale" on page 83
If the encoder scale is dirty, the printer will not be able to read the print area accurately
and print quality will decline. We recommend cleaning it immediately if this message is
displayed.
Check the following points, and then press OK.
❏
If there are wrinkles in the surface of the media that is loaded on the platen, reload
the media so it is flat.
❏
When loading thick media, check that the spacer combination and platen height
(scale) are suitable for the media.
"Determining the Height of the Platen" on page 56
❏
Confirm that nothing has fallen into the printer.
Check the following points, and then press OK.
❏
Remove anything that is on the platen other than the media.
❏
If the surface of the media has risen up or become extremely wrinkled, reload the
media so it is flat.
❏
When you have changed the platen type, check that the spacer combination
and platen height (scale) are suitable for the platen type you are using and the
thickness of the loaded media.
"Determining the Height of the Platen" on page 56
❏
Remove anything that has fallen around the movable base.
Printer has exceeded the temperature at which its operations are guaranteed. Adjust
the temperature of the room, and then start again.
"Specifications Table" on page 147
You cannot perform Reprint unless a USB memory stick is connected to the printer.
"When reprinting (repeat printing) the same job" on page 70
113