Table of Contents
Advertisement
LCD screen message
Condition/solution
Cannot move the
Check the following and then select OK:
movable base.
• Remove anything that is on the platen that is not media.
Check around the
• Make sure there are no wrinkles on the surface of the loaded media.
movable base, and then
press [OK].
• Check that the spacer combination and platen height (scale) are suitable
• Remove anything that has fallen around the movable base.
Failed to inspect the
The printer has exceeded the temperature at which normal operation is
condition of nozzles.
guaranteed. Adjust the temperature of the room and start again.
Cannot run "Auto
Cleaning".
Select cleaning strength
manually and run
Cleaning.
No reprint data found.
You cannot reprint a print job unless a USB memory stick is connected to the
printer.
A memory device or
USB memory stick is
required to reprint.
See your documentation
for details.
Cannot use the inserted
Check the following:
Memory Device.
• The USB memory stick may be corrupt. Use a different USB memory stick.
For details, see your
• There is not enough free space on the USB memory stick or the maximum
documentation.
• The USB memory stick was removed from the printer while data was being
Reload the media so that it is flat.
for the media you are using.
number of readable files (999) has been exceeded. Delete any
unnecessary files or use a different USB memory stick.
written or read. Before removing the USB memory stick, make sure that
the light on the device is not flashing or on.
163
Advertisement
Table of Contents
