Table of Contents
Advertisement
1.
Display's NETWORK connector.
2. RayNet to RayNet cable — Connect one end of the RayNet cable to your
display, and the opposite end to a RayNet device or RayNet network
switch.
3. RayNet to RJ45 adapter cable — Connect the RayNet end of the cable
to your display, and the opposite end to a network device with an RJ45
connector, or an RJ45 coupler.
4. Example compatible network devices with RayNet or RJ45 connectors
(e.g.: Radar scanners, Sonar modules, Displays, Network switches,
Cameras etc).
For a list of available network cables refer to
accessories
Cable suppression ferrites
To ensure optimum EMC performance and to comply with applicable
EMC regulations all RayNet cables connected to this product must have
a suppression ferrite fitted.
Three suppression ferrites are included with your display, one for each
RayNet connection.
Fit a ferrite to each RayNet cable as shown below:
64
Chapter 24 Spares and
• Cable clips (not supplied) should be used to support the cable and ferrite.
• If you need to remove a ferrite for any reason, ensure it is replaced in its
original location before using the product.
• If the ferrite moves freely once fitted use cable ties (not supplied) above
and below the ferrite to secure it in place.
11.5 Internet connection
Some features require the display to have a connection to the internet.
Note:
In versions of the YachtSense ™ Link router software later than v4.20, the
display cannot connect to the router's Wi-Fi access point.
The display can be connected to the internet using the following methods:
• Connecting the display's Wi-Fi connection to a Wi-Fi access point which
has an internet connection, such as marina Wi-Fi or mobile device. For
connection details, refer to:
p.65 — Connecting to the internet using Wi-Fi
• Connecting the display's RayNet Ethernet connection to a YachtSense ™
Link router which has internet access. Requires YachtSense ™ Link router
software v4.20 or above
• Connecting the display's Wi-Fi connection to a YachtSense ™ Link router
which has internet access. Requires YachtSense ™ Link router software
v4.17 or earlier.
• Connecting the display's Wi-Fi or RayNet Ethernet connection to a
third-party router which has internet access
Note:
• When connecting to a YachtSense ™ Link router, follow the instructions
provided with the router to set up an internet connection.
• When using a third-party router, follow the instructions provided with
it to set up an internet connection and then follow the guidance in
the appendix of this document to help you configure internet access:
p.128 — IP Networking of Raymarine devices with Third-party products
Advertisement
Table of Contents
Troubleshooting
