Appendix C Original Trunnion Kit Mounting; Axiom® 2 Pro 16 - Raymarine AXIOM 2 PRO Installation Instructions Manual

Appendix C Original trunnion kit mounting —
Axiom® 2 Pro 16
Tools required (trunnion mount installations)
The following tools are recommended for mounting using a trunnion bracket:
1. Power drill.
2. Screwdriver (appropriate for your fixings).
3. Drill bit (suitable for the mounting surface material and the 5.75 mm
(0.23 in) diameter holes in the trunnion bracket).
4. Torque wrench.
5. Loctite® 243, or equivalent threadlocker.
6. Small flat blade screwdriver (or plastic pry tool).
7. 13 mm (1/2") socket.
Display trunnion mounting preparation
Axiom® 2 Pro 16 displays are intended to be either surface or flush mounted.
An optional Trunnion bracket kit (part number: A80722) is available if
trunnion mounting is desired. For trunnion mounting, the display needs to be
prepared using the parts supplied in the A80722 kit.
Important:
The display is supplied with rubber trunnion bungs fitted, which must be
removed before the display is trunnion mounted. Do NOT attempt to
trunnion mount the display using the trunnion bungs.
124
To prepare the display for trunnion mounting, follow the steps below, for
both sides of the display:
1. Insert a small flat blade screwdriver or plastic pry tool into the center
hole of the Trunnion bung.
2. Lever the tool up or down to release the Trunnion bung.
3. Remove the Trunnion bung.
4. Insert the Spacer piece into the display with the flat edge facing forward.
Important:
Do NOT fit the ratchet plate to the spacer before tightening the standoff
bolt.
5. Slide the M8 washer over the M8 standoff bolt.
6. Apply Loctite® 243 (or equivalent threadlocker) to the thread of the M8
standoff bolt.
7. Insert the M8 standoff bolt and tighten to 20 N·m (14.75 lbf·ft).