Cable Suppression Ferrites - Raymarine AXIOM 2 PRO Installation Instructions Manual

2. RayNet to RayNet cable — Connect one end of the RayNet cable to your
display, and the opposite end to a RayNet device or RayNet network
switch.
3. RayNet to RJ45 adapter cable — Connect the RayNet end of the cable
to your display, and the opposite end to a network device with an RJ45
connector, or an RJ45 coupler.
4. Example compatible network devices with RayNet or RJ45 connectors
(e.g.: Radar scanners, Sonar modules, Displays, Network switches,
Cameras etc).
For a list of available network cables refer to
accessories

Cable suppression ferrites

To ensure optimum EMC performance and to comply with applicable
EMC regulations all RayNet cables connected to this product must have
a suppression ferrite fitted.
Three suppression ferrites are included with your display, one for each
RayNet connection.
Fit a ferrite to each RayNet cable as shown below:
Network connections
Chapter 24 Spares and
• Cable clips (not supplied) should be used to support the cable and ferrite.
• If you need to remove a ferrite for any reason, ensure it is replaced in its
original location before using the product.
• If the ferrite moves freely once fitted use cable ties (not supplied) above
and below the ferrite to secure it in place.
61