Regulatory Notices; Regulatory E-Label; Declaration Of Conformity; Rf Exposure - Raymarine AXIOM 2 PRO Installation Instructions Manual

Caution: Product weight
• Refer to the technical specification for your product to
ensure the intended mounting surface is suitable to bear
its weight.
• 2 people may be required for installation of larger / heavier
products.
Caution: Power supply protection
When installing this product ensure the power source is
adequately protected by means of a suitably-rated fuse or
thermal circuit breaker.
Caution: Sun covers
• If your product is supplied with a sun cover, to protect
against the damaging effects of ultraviolet (UV) light, always
fit the sun cover when the product is not in use.
• To avoid potential loss, sun covers must be removed when
travelling at high speed, whether in water or when the
vessel is being towed.
Caution: Service and maintenance
This product contains no user serviceable components. Please
refer all maintenance and repair to authorized Raymarine
dealers. Unauthorized repair may affect your warranty.

Regulatory notices

Regulatory e-Label

All the applicable regulatory and compliance standards for your product
are listed in electronic format in a regulatory "e-label" document, which can
be viewed on your product's display.
To access the Regulatory e-Label for your product:
From the Homescreen: [Settings > Getting Started > Regulatory Approvals]
Important information

Declaration of Conformity

Raymarine UK Ltd declares that the products listed below are in compliance
with the EMC Directive 2014/53/EU:
• Axiom® 2 Pro 9 S multifunction display, part number E70653
• Axiom® 2 Pro 9 RVM multifunction display, part number E70654
• Axiom® 2 Pro 12 S multifunction display, part number E70655
• Axiom® 2 Pro 12 RVM multifunction display, part number E70656
• Axiom® 2 Pro 16 S multifunction display, part number E70657
• Axiom® 2 Pro 16 RVM multifunction display, part number E70658
The original Declaration of Conformity certificate may be viewed on the
relevant product page at www.raymarine.com/manuals

RF exposure

This equipment complies with FCC / ISED RF exposure limits for general
population / uncontrolled exposure. The wireless LAN / Bluetooth antenna
is mounted behind the front facia of the display. This equipment should be
installed and operated with a minimum distance of 1 cm (0.39 in) between the
device and the body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter, except in accordance with
FCC multi-transmitter product procedures.

Compliance Statement (Part 15.19)

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.

FCC Interference Statement (Part 15.105 (b))

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
11