Surface Mounting; Tools Required (Surface Mount Installations) - Raymarine AXIOM 2 PRO Installation Instructions Manual

1. Ensure you have followed the instructions for
preparing the mounting surface for flush mounting:
p.46 — Preparing the mounting surface — flush mounting
2. Route the relevant cables to the area behind the mounting surface cutout.
This may be difficult or not possible once the display has been mounted.
3. Remove the backing from the supplied gasket and place the sticky side of
the gasket onto the flange on the rear of the display. Press firmly onto
the flange.
4. Connect the relevant cables to the rear of the display.
5. Slide the display into the cutout area.
6. Pull back the 3 corner bungs and open the card reader door.
7. Insert the fixing bolts, attach the washers and nuts from the rear, and
then tighten.
8. Close the 3 corner bungs and the card reader door.
48
Note:
The supplied gasket provides a seal between the display and a suitably
flat and rigid mounting surface or binnacle. The gasket should be used in
all installations. It may also be necessary to use a marine-grade sealant
if the mounting surface or binnacle is not entirely flat and/or has a rough
surface finish.

8.6 Surface mounting

Tools required (surface mount installations)

The following tools are recommended for surface mount installations:
1. Power drill.
2. Hole cutter (appropriate size for corner diameters of the Cutout line
identified on the supplied mounting template):
• 33.00 mm (1.30 in) — Axiom® 2 Pro 9.
• 37.00 mm (1.47 in) — Axiom® 2 Pro 12 / Axiom® 2 Pro 16.
3. Jigsaw.
4. Half round file (or sandpaper).